THREADED ADAPTER + SHIFT BOOT RETAINER INSTALL GUIDE
4mm Allen Wrench
Side Cutter Snips
1 \ REMOVE YOUR SHIFT KNOB
Remove your shift knob. This may require some strength to get the shift knob loose from the shifter arm.
2 \ INSTALL BOOT RETAINER
Slide the shift boot retainer over the shifter arm with the o-rings facing up.
3 \ INSPECT YOUR SHIFTER ARM
Take a close look at the threads on your shifter arm and clean if nessecary.
4 \ APPLY BLUE LOCTITE
Apply a pea sized amount of blue loctite to the threads on your shifter arm. Using too much blue loctite will not allow it to dry and thus not work properly.
5 \ INSTALL THE ADAPTER
Thread the adapter onto the shifter arm by hand than use a 15mm wrench to install the threaded adapter all the way down and tighten it onto the shifter arm. Make sure the adapter is tight!
6 \ LET IT DRY
Let the blue Loctite set-up 10-15 minutes, then proceed to the next step.
7 \ REMOVE SHIFT BOOT
Remove your shift boot bezel from the center console. Refer to google to find vehicle specific removal instructions.
8 \ ATTACH THE SHIFT BOOT
Flip the shift boot inside out. Use the zip tie to attach the inside of the shift boot to the shift boot retainer.
9 \ REINSTALL SHIFT BOOT
Install the shift boot bezel into the center console.
10 \ INSTALL THE KNOB
Install the shift knob by screwing it onto the adapter till its snug.
11 \ INSTALL SHIFT BOOT RETAINER
Slide the shift boot retainer into the bottom of the shift knob until the shift boot is snug with the base of the shift knob.
1 \ HOW IT WORKS
The shift knob bottoms out on the top of the flat head screw. Turning the screw clockwise or counterclockwise will rotate the shift gate pattern the same amount and direction the screw was turned. Follow the steps below to adjust the shift gate pattern.
2 \ TAKE MEASUREMENT
Take note of how many degrees clockwise or counterclockwise the shift knob orientation is off
3 \ REMOVE SHIFT KNOB
Unscrew the shift knob. Use a 4mm allen wrench and turn the flat head screw the same amount of degrees in the direction the orientation is off by. If the engraving is pointed to the right turn the screw out or counter clockwise and vice versa for other direction.
4 \ REINSTALL SHIFT KNOB
Check your orientation adjustment by threading the shift knob onto the adapter.
5 \ REPEAT TILL PERFECT
Check your shift knob orientation. Repeat step 1 if further adjustment is needed.
6 \ ENJOY THE DRIVE
Test drive and enjoy your new shifting experience!