THREADED ADAPTER INSTALL GUIDE



TOOLS REQUIRED
1" Wrench or Adjustable Wrench
1/8" Allen Wrench
Side Cutter Snips
Blue Loctitie




1 \ REMOVE YOUR SHIFT KNOB
Remove your shift knob. Refer to google to find vehicle specific removal instructions.



2 \ REMOVE YOUR SHIFT BOOT
Remove the shift boot from the center console. Refer to google to find vehicle specific removal instructions.



3 \ REMOVE OEM SHIFT BOOT RETAINER
Once you have the shift boot removed fold the inside out and you will see a plastic shift boot retainer. This needs to be removed for proper installation of our adapter and shift knob.



4 \ SHIFT BOOT PARTIAL INSTALL
Once you have the OEM shift boot retainer removed place the shift boot back onto your shifter arm but do not fully install back into the console.



5 \ REMOVE SET SCREWS
Remove the small set screws from the adapter and set aside we will need them later.



6 \ INSTALL THE ADAPTER
Slide the adapter onto the shifter arm with the threaded portion of the adapter facing up. Make sure the adapter is a far down as possible, best way to tell is the top of the shifter arm is touching the top of the adapter.



7 \ APPLY BLUE LOCTITE
Place a small dab of blue Loctite on the set screws you removed previously.



8 \ INSTALL SET SCREWS
Uncrew the jam nut until its at the top of the adapter threads and use an 1/8in allen wrench to tighten the set screws starting at the top, make sure to not over tighten to not cause the metal to deform and not allow proper shift knob installation.



9 \ DOUBLE CHECK
Check to make sure the set screws are not over tightened by spinning the jam nut. If the jam nut does not spin, back out the screws a very small amount. The jam nut can have a small amount of resistance but not too much to the point where it does not spin.



10 \ ALIGN THE ENGRAVING
If you have a shift knob with engraving make sure the jam nut is screwed all the way down to the bottom of the adapter. Install the shift knob as far down as possible, once fully installed back off the shift knob until the engraving is perfectly aligned. Once you have the engraving in your desired orientation take the jam nut and unscrew until its snug with the bottom of the shift knob, using your wrench while holding the shift knob you want to tighten the jam nut to the bottom of the shift knob. This will lock the knob and jam nut together to hold the shift knob in place.



11 \ BOOT CRACK ELIMINATION
Once your shift knob is aligned and locked to the jam nut you are going to take your shift boot and fold it inside out and lift over the shift knob and jam nut but do not complete remove. With the shift boot opening now aligned with the jam nut, use your zip tie to attach the shift boot to the jam nut. Trim the zip tie using a side cutter snips.



12 \ SHIFT BOOT FINAL INSTALL
Now that your shift boot is attached to the adapter you can now fully install the shift boot back into your center console.



13 \ ENJOY THE DRIVE
Test drive and enjoy your new shifting experience!