TOOLS REQUIRED
15mm Wrench
4mm Allen Wrench
Blue Loctite
1 \ REMOVE YOUR SHIFT KNOB
Remove your shift knob. Refer to google to find vehicle-specific removal instructions.
2 \ INSPECT YOUR SHIFTER ARM
Take a close look at the threads on your shifter arm and clean if necessary.
3 \ APPLY BLUE LOCTITE
Apply a pea-sized amount of blue Loctite to the threads on your shifter arm. Using too much blue Loctite
will not allow it to dry and thus not work properly.
4 \ INSTALL THE ADAPTER
Thread the adapter onto the shifter arm by hand then use a 15mm wrench to install the threaded adapter all the
way down and tighten it onto the shifter arm. Make sure the adapter is tight!
5 \ LET IT DRY
Let the blue Loctite set up for 10-15 minutes, then proceed to the next step.
6 \ INSTALL THE KNOB
Install the shift knob by screwing it onto the adapter till it's snug. If you have an engraved
shift knob follow the steps below to align the engraving.
ENGRAVING ORIENTATION
1 \ HOW IT WORKS
The shift knob bottoms out on the top of the flat head screw. Turning the screw clockwise or
counterclockwise will rotate the shift gate pattern in the same amount and direction the
screw was turned. Follow the steps below to adjust the shift gate pattern.
2 \ TAKE MEASUREMENT
Take note of how many degrees clockwise or counterclockwise the shift knob orientation is off
3 \ REMOVE SHIFT KNOB
Unscrew the shift knob. Use a 4mm Allen wrench and turn the flat head screw the same
amount of degrees in the direction the orientation is off. If the engraving is pointed to the
right turn the screw out or counterclockwise and vice versa in other direction.
4 \ REINSTALL SHIFT KNOB
Check your orientation adjustment by threading the shift knob onto the adapter.
5 \ REPEAT TILL PERFECT
Check your shift knob orientation. Repeat step 1 if further adjustment is needed.
6 \ ENJOY THE DRIVE
Test drive and enjoy your new shifting experience!