TOOLS REQUIRED

15mm Wrench
4mm Allen Wrench
Side Cutter Snips
Blue Loctite

 

1 \ REMOVE YOUR SHIFT KNOB

Remove your shift knob. Refer to google to find vehicle-specific removal instructions.

 

2 \ INSTALL BOOT RETAINER

Slide the shift boot retainer over the shifter arm with the o-rings facing up.

 

3 \ INSPECT YOUR SHIFTER ARM

Take a close look at the threads on your shifter arm and clean if necessary.

 

4 \ APPLY BLUE LOCTITE

Apply a pea-sized amount of blue Loctite to the threads on your shifter arm. Using too much blue Loctite

will not allow it to dry and thus not work properly.

 

5 \ INSTALL THE ADAPTER

Thread the adapter onto the shifter arm by hand then use a 15mm wrench to install the threaded adapter all the

way down and tighten it onto the shifter arm. Make sure the adapter is tight!

 

6 \ LET IT DRY

Let the blue Loctite set up for 10-15 minutes, then proceed to the next step.

 

7 \ REMOVE SHIFT BOOT

Remove your shift boot bezel from the center console. Refer to google to find vehicle-specific

removal instructions.

 

8 \ ATTACH THE SHIFT BOOT

Flip the shift boot inside out. Use the zip tie to attach the inside of the shift boot to the shift

boot retainer.

 

9 \ REINSTALL SHIFT BOOT

Install the shift boot bezel into the center console.

 

10 \ INSTALL THE KNOB

Install the shift knob by screwing it onto the adapter till it's snug.

 

11 \ INSTALL SHIFT BOOT RETAINER

Slide the shift boot retainer into the bottom of the shift knob until the shift boot is snug with

the base of the shift knob.

 

ENGRAVING ORIENTATION

 

1 \ HOW IT WORKS

The shift knob bottoms out on the top of the flat head screw. Turning the screw clockwise or

counterclockwise will rotate the shift gate pattern in the same amount and direction the

screw was turned. Follow the steps below to adjust the shift gate pattern.

 

2 \ TAKE MEASUREMENT

Take note of how many degrees clockwise or counterclockwise the shift knob orientation is off

 

3 \ REMOVE SHIFT KNOB

Unscrew the shift knob. Use a 4mm Allen wrench and turn the flat head screw the same

amount of degrees in the direction the orientation is off. If the engraving is pointed to the

right turn the screw out or counterclockwise and vice versa in other direction.

 

4 \ REINSTALL SHIFT KNOB

Check your orientation adjustment by threading the shift knob onto the adapter.

 

5 \ REPEAT TILL PERFECT

Check your shift knob orientation. Repeat step 1 if further adjustment is needed.

 

6 \ ENJOY THE DRIVE

Test drive and enjoy your new shifting experience!