NON - THREADED ADAPTER INSTALL GUIDE




TOOLS REQUIRED
1/8" Allen Wrench
3/32" Allen Wrench for Mini Cooper Adapters
Side Cutter Snips
Blue Loctite




1 \ REMOVE YOUR SHIFT KNOB
Remove your shift knob. Refer to google to find vehicle specific removal instructions.



2 \ REMOVE YOUR SHIFT BOOT
Remove the shift boot from the center console. Refer to google to find vehicle specific removal instructions.



3 \ REMOVE SET SCREWS
Remove the small set screws from the adapter and set aside we will need them later.



4 \ INSTALL THE ADAPTER
Slide the adapter onto the shifter arm with the threaded portion of the adapter facing up.



5 \ APPLY BLUE LOCTITE
Place a small dab of blue Loctite on the set screws you removed previously. Lightly tighten the set screws so the adapter does not spin.



6 \ INSTALL THE KNOB
Install the shift knob by screwing it onto the adapter until it bottoms out. If you have an engraved shift knob follow the steps below to align the engraving, if unengraved skip the next step.



7 \ ALIGN THE ENGRAVING
If you have a shift knob with engraving, loosen the set screws and rotate the adapter till the engraving pattern is lined upcorrectly. Tighten the set screws when you are satisfied with the engraving position.



8 \ BOOT CRACK ELIMINATION
Remove the shift knob. Fold your shift boot inside out and place the top of it over the adapter. Zip-tie the shift boot to theshoulder located below the adapter threads. Trim the zip-tie with a side cutter.



9 \ SHIFT KNOB FINAL INSTALL
Reinstall the shift boot and the shift knob.



10 \ ENJOY THE DRIVE
Test drive and enjoy your new shifting experience!